Soft Top
Bronco Specs
Solid Axle Swap
rear lift blocks
Favorite Links
Contact Me
Ryan's 1990 Bronco Tech Page
rear lift blocks

This project originated from the fact that my 38" swampers dug into my quarter panels when flexed out. I built blocks that would relocate my rear axle 1.5" rearward. they are also 1.5" tall and have a 5 degree taper to corectly establish my rear pinion angle. they were machined from 7075 aluminum and are a full 3" wide. they worked out better than i ever expected. in the picture you can see how the axle now sits 1.5" BEHIND the leaf spring centering pin.